Load shedding: keeping your tank alive through power cuts
What actually happens when the filter stops for hours, and a simple plan for air, temperature, feeding and restarting.
Load shedding is part of life in Rawalpindi and Islamabad, and most tanks get through a 1–2 hour power cut without any trouble. Longer cuts, and cuts on very hot days, are where things go wrong. With a little planning, a power cut becomes a non-event.
What actually happens when the power goes
- The filter stops. The good bacteria living in the filter need oxygen. Without flow, the water inside the filter runs out of oxygen, and after several hours the bacteria start to die.
- Oxygen in the tank drops. No filter and no air pump means less mixing at the surface. Warm water makes this much worse.
- Temperature drifts. In summer the fan and AC stop and the water warms up. In winter it cools down.
Oxygen is what matters most. Keep air going into the water and almost everything else can wait.
The best setup for load shedding
Run a Sponge Filter with an Air Pump, and plug the air pump into your UPS or inverter. The air pump uses only a few watts, so it barely touches your battery, and it keeps both the filter and the oxygen going right through the cut. This is the main reason we recommend sponge filters for Pakistani homes.
If you don’t have a UPS
- A battery or USB air pump. Small air pumps that run on batteries or a power bank are cheap and last for hours. Keep it ready with spare batteries and a spare air stone.
- Stir the surface by hand every half hour or so for a minute or two. Moving the surface lets in oxygen.
- Keep the lid open so air can reach the water.
During a long cut
- 1Don’t feed. Food means waste and waste uses up oxygen. Healthy shrimp and fish can easily go several days without food.
- 2Keep air going with one of the options above.
- 3Watch the temperature. In summer, keep the room as cool as you can and the tank out of sun. In winter, keep the lid on and cover the tank with a towel to hold the heat.
- 4Don’t open or clean the filter while the power is off.
When the power comes back
- Sponge filters: simply start again. No action needed.
- Hang-on-back and internal filters: after a long cut, rinse the media gently in a bucket of tank water before restarting, so stale water doesn’t flush straight into the tank.
- Canister filters: the water sealed inside goes stale quickly, especially in warm weather. If it has been off for more than 2–3 hours, open it, rinse the media in tank water, then restart.
- Test the water the same day if the cut was long: ammonia and nitrite should still read 0. If not, do a partial water change and feed lightly for a few days.
Never rinse filter media under the tap. Chlorine kills the bacteria you’ve been protecting. Always rinse in old tank water.
A simple load shedding checklist
- Air pump plugged into the UPS or inverter, or a battery air pump ready with spare batteries.
- A thermometer on the tank.
- In summer: a rechargeable fan.
- Know your area’s load shedding schedule, and don’t do water changes or filter cleaning just before a cut.
